Quantum-data 881 Bedienungsanleitung PDF herunterladen (Seite 50)

32 Chapter 1 Getting Started

Configuring the generator’s serial port

The following procedures describe how to change the generator’s default serial port

configuration for a terminal session. You can configure the serial port through either the

front panel, Virtual Front Panel or through the command line interface.

To configure the generator’s serial port through the front panel or Virtual

Front Panel:

1. Press the Tools key. The Tools menu appears on the generator’s display as shown

below.

2. Choose the System item by pressing the adjacent soft key. The System menu appears

on the generator’s display as shown below.

3. Choose the Serial item by pressing the adjacent soft key. The serial port settings

appear on the generator’s display.

Selec

4. Press the Settings key. The following information appears on the generator’s display:

5. To change the baud rate, do the following:

a. Position the blinking cursor on the baud rate setting. To do this, press the soft key

adjacent to the arrow by the baud rate setting to move the cursor left or right until

it appears on the baud rate setting.

b. Press the + or - keys to adjust the baud rate setting up or down.

System

Sequence

Probe

AFC

Analyzer

Reports

ImgShift

CEC

Clock Clone*

CalFactor Server

Network About

Serial GPib

Serial Port

9600 baud

8 N 1

Serial Port

Set Params

BAUD FLOW ->

9600 N ->

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 125 126

Keine Kommentare

Quantum-data 881 Bedienungsanleitung Seite 50