Quantum-data 802BT Bedienungsanleitung PDF herunterladen (Seite 198)

100

101

188 Chapter 11 Testing HDCP

Testing HDCP between HDMI transmitter and DVI receiver

HDCP 1.1-compliant devices must interoperate with HDCP 1.0 compliant devices using

the DVI protocol. Generators with an HDMI transmitter can be used to test HDCP with

devices that have an DVI receiver.

To test HDMI Tx with DVI Rx:

1. Hold down the G and B key while starting the generator put the generator in digital

friendly mode.

Alternatively, enter the following command:

SROP 2

2. Establish a command terminal connection with the generator, using HyperTerminal or

VGM.

3. At the R:> prompt, enter the following to set the HDMI transmitter into DVI mode, which

disables audio:

HDMI 0

ALLU

The DVI mode setting is saved until you change it.

4. Use an HDMI-to-DVI cable (provided with HDMI generator) to connect the HDMI

transmitter to the DVI receiver.

5. Load the HdcpProd image. This image assumes that both the transmitter and receiver

are using production keys.

The image will indicate if the test passed or failed. If the test fails, see “Troubleshooting

HDCP errors” on page 191.

To change HDMI transmitter from DVI to HDMI mode:

1. Establish a command terminal connection with the generator, using HyperTerminal or

VGM.

2. At the R:> prompt enter the following to invoke the HDMI mode:

HDMI 1

ALLU

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 743 744

Kommentare zu diesen Handbüchern

Keine Kommentare

Quantum-data 802BT Bedienungsanleitung Seite 198

Kommentare zu diesen Handbüchern