Quantum-data 802BT Bedienungsanleitung PDF herunterladen (Seite 100)

100

101

90 Chapter 6 Working with Test Sequences

deactivate the mode status of all other sequence files. If a start-up mode is not set for

any sequence file, then the generator will start in the normal operating mode.

9. Press Save (DCS) to save the sequence file. Use the Format and Image knobs to

specify a name for the file by selecting the characters presented.

10. Press Exit (Image) to exit the Sequence Editor, and to return to the Sequence List

editor.

To edit the list of sequences that can be used:

1. Hold down the Image key while starting the generator, until programmer is displayed.

2. Select the SeqList image.

3. Press the Image key to start the Sequence List editor.

The Sequence List box shows a list of sequence files that can be selected with the

Format knob. The Available Files box shows all sequence files available.

Mode Display option Description

blank If no mode is specified the sequence is not started when the

generator is started.

step Use the Image knob to advance through sequence steps.

You cannot advance past the last step. However, rotating the

Image knob forward one revolution past the last step will

change the mode to automatic. Rotating the Image knob

backward one revolution changes the mode back to manual.

Step information is displayed on the LCD only.

step -s# Current step number is displayed with image on display

being tested.

step -display Complete step information (sequence name, format, image,

and step number) is displayed with image on display being

tested.

wrap Use Image knob to advance through sequence steps.

Advancing past the last step restarts at the first step.

Step information is displayed on the LCD only.

wrap -s# Current step number is displayed with image on display

being tested.

wrap -display Complete step information is displayed with image on dis-

play being tested.

auto Automatically and continuously cycles though sequence

steps, and displays step information on LCD only.

auto -s# Current step number is displayed with image on display

being tested.

auto -display Complete step information is displayed with image on dis-

play being tested.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 743 744

Kommentare zu diesen Handbüchern

Keine Kommentare

Quantum-data 802BT Bedienungsanleitung Seite 100

Kommentare zu diesen Handbüchern