Quantum Data 801GF Spezifikationen PDF herunterladen (Seite 16)

Page 16 Model 801GC-ISA & 801GF-ISA Programming Manual

AVSS <level>

Limits: <level> > (floating point accepted)

min = 0.000 volts

max = 0.715 volts

Description: The AVSS command sets the maximum peak-to-peak swing for all three analog video

channels. The actual peak-to-peak swing of the analog video signals at the output connectors

is equal to the product of: AVSS multiplied by AVSC. The AVSS? query returns the current

setting of AVSS.

AVST <type>

Limits: <type>

0=none

1=Analog Y (grayscale)

2=Analog RGB (color)

3=Analog TV Y (grayscale)

4=Analog TV EYC (color subcarrier)

5=Analog YPrPb (color difference)

Must be zero (0) when any digtal video type is selected (DVST ? 0).

Description: The AVST command establishes the type of signal that appears on the analog video outputs

of the generator. The AVST? query returns the current setting of AVST.

BASE <radix>

Limits: <radix> = 0 to 36

Description: The BASE command establishes the radix of address and data parameters passed-to or

returned-from the ADDR, GETA, GETR, PUTA, PUTR, and CALL instructions. If a negative

radix is specified, then parameters passed (or returned) from these functions are assumed to

be signed. For example, if BASE= -16, then the value -1 is used to communicate the value

FFFFFFFF hex. The BASE? query returns the current setting of BASE. The radix <radix> is

always passed and returned in base 10, regardless of the setting of BASE. BASE is preset to -

10 each time the generator is powered on. Base -10 is the preferred radix. The BASE? query

returns the current setting of BASE.

BOOT

Description: Warm Boot

CACH <mode>

Limits: <mode>

0 = OFF

1 = ON

Description: Instruction Cache Enable

CALF <Video 1000> <Video 700> <Sync 400> <Sync 40> <NTSC714> <PAL700>

Limits:

Description: Analog video calibration factors

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Keine Kommentare

Quantum Data 801GF Spezifikationen Seite 16